Spine and more
After our first longer tour through Norway and Sweden, it quickly became clear to us that if we were to drive for a longer period of time, we would have to get new seats in the car.
There is a large selection of seats for the Defender and the quality is very different. So you quickly end up with well-known manufacturers such as Recaro, König and co.
When looking for a German manufacturer of seats, we discovered the Greiner company in our immediate vicinity.
Greiner produces the LR Traveler seats exclusively for the Defender which, like the original, has a foldable seat. After more than 6000km with these seats we don't want to miss them anymore.
Why buy the LandRover Edition only?
- Seat can be folded up 90 °
- fits perfectly in the Defender of fit and appearance
- High gain in comfort
- good seat heating (optional)
Modify the seat heater
The conversion of the seat heating is done quickly thanks to the fully pre-assembled cable harnesses.
We had already installed a seat heater as standard in our model, which made the conversion almost plug & play.
For the connection with the original switches and existing connections, only a plug of the type YPC116820, single wire seal and terminal is required. We found what we were looking for on Ebay.
The pin assignment in the YPC116820 was 1 (+) and 2 (-). You can measure this in the existing connector with the help of test probes and a multimeter for direct current setting.
We shortened the existing wiring harness at the plugs and connected the plus poles (red-black) and minus poles (black and yellow-black) to the LR plug with the help of Wago connector.
We had already installed a seat heater as standard in our model, which made the conversion almost plug & play.
For the connection with the original switches and existing connections, only a plug of the type YPC116820, single wire seal and terminal is required. We found what we were looking for on Ebay.
The pin assignment in the YPC116820 was 1 (+) and 2 (-). You can measure this in the existing connector with the help of test probes and a multimeter for direct current setting.
We shortened the existing wiring harness at the plugs and connected the plus poles (red-black) and minus poles (black and yellow-black) to the LR plug with the help of Wago connector.
